Differences

This shows you the differences between two versions of the page.

--- library:slice_thickness [2025/07/08 15:41] – scott
+++ library:slice_thickness [2025/07/08 18:17] (current) – scott
@@ Line 6: / Line 6: @@
 ===Slice Selective Excitation===
+In order to acquire a single slice, a discrete volume of tissue needs to be excited, while leaving any neighboring tissues unaffected so they don't corrupt the signal from the area of interest. The MR scanner achieves this with a combination of gradients and radiofrequency pulses. It is a multi-step process that occurs quickly- on the order of micro to milliseconds. Keeping in mind that once the patient is inside the magnet, some of the protons in their tissues become magnetized and generally align along the b0 field of the scanner and precess at a known frequency; ~63MHz for 1.5 Tesla or 128 MHz for 3 Tesla.
+  - A gradient is imposed perpendicular to the desired slice; this changes the Larmor Frequency along that direction linearly. This is known as the slice select gradient.
+  - At the same time as the Slice Select gradient is activated, a radiofrequency pulse will be played out over a few thousand hz, corresponding to the desired slice thickness. This is known as the RF transmit bandwidth.
+By modifying either the transmit bandwidth and the strength of the slice select gradient, different slice thickness may be achieved. Typically the transmit bandwidth is not changed much, rather it is the slice select gradient that is primarily used to determine slice thickness. In the example below, a 2000 hz range of frequencies between 63 and 63.5 MHz is transmitted while a gradient is turned on, exciting a slice of tissue (green) a a little above isocenter; in this process both the slice thickness and location are determined by the RF and gradient combination.
+{{ :library:slice_selection.png?600 |}}